1988-1997 Ford truck and van 7.5 / 460 high flow water pump with remote oil cooler or for swaps when using the serpentine brackets

(This has the standard large inlet and works with serpentine brackets and remote oil cooler lines.  IT DOES NOT WORK WITH OIL/HEAT EXCHANGER BOX that is part of the oil filter bracket)

1988-1997 Ford F-250, F-350, F-450 / Super duty,  with 7.5 460
1988-1997 Ford E-250 E-350 Econoline Van or Rv
any year swap when using the serpentine brackets

$195.00

SKU: 92-94-hf-wp Category:

Share this product

Description

Simply put, a stock volume water pump falls sadly short on a stock 460 powered truck, they simply don’t move enough volume. Even stock engines will fluctuate in temperature drastically from this problem. I have never seen anyone’s water pump keep up with these units. If you do any towing or have increased the power of your engine you will need help to move that massive amount of coolant faster. Your Ford engine and the ECU needs to stay within a specific temperature range to operate correctly. Too cold and you waste fuel, get too hot and the ECU leans the air fuel curve and overheats the engine even further. We searched high and low for a pump that actually worked with the stock radiator tubes, pump shaft, and fan bolt pattern. We were thrilled to find Flowkooler water pumps. But before we offered or recommended any part to anyone we thoroughly tested these first. We installed a few on our built up engines we were installing. What we found was this pump always held the temperature much much closer to the thermostat rating than you could ever expect out of a stock water pump.

Reviews

There are no reviews yet.

Be the first to review “1988-1997 Ford truck and van 7.5 / 460 high flow water pump with remote oil cooler or for swaps when using the serpentine brackets”