1977-1979 – F-250/F-350 4X4 MOTOR MOUNT PERCHES
These are an upgraded replacement for the 351m/400 motor mount perches. If your’s are missing or damaged, these will work for you – or if you are looking to swap in a 460 these can be used with our 460 Swap Motor Mounts.
1988-1997 – FORD F-250/F-350 2WD/4WD 460 MOTOR MOUNT KITS
Ditch those squishy water bed style factory motor mounts. These Bullet-Proof motor mount kits will bolt directly in place of the factory mounts. Our goal was to make a quality mount that could handle high horsepower, keep your motor locked down and be smooth enough to use as a daily driver. These are built so well if there’s ever an issue, we replace them free of charge.
460/429 : Low Profile EFI Kit
OUR NEWEST UPGRADE IS A LOW-PROFILE THROTTLE BODY THAT IMPROVES THROTTLE RESPONSE, HP AND TORQUE. IT LETS YOU KEEP THE VINTAGE AIR CLEANER OF YOUR CHOICE. THIS UNIT COMES STOCK ON ALL THE INTAKE SWAP KITS AND IS ALSO FOR SALE SEPARATELY.
Low Profile Throttle Body – 7.5 Liter 460
** DOES NOT WORK WITH MAF (Mass Air Flow trucks) **
SPEED DENSITY HAVE 2 INTAKE TUBES CONNECTED TO THE AIR FILTER BOX
Included with this kit:
- Holley low profile throttle body, throttle cable and all needed sensors
- Throttle cable housing, inner-cable, and needed fittings for throttle and cruise control
- Idle air bypass, pigtail and tube
- Throttle position sensor and pigtail
- 5/8″ tubing and elbow for driver side breather port
- 14″ Air Filter Base (we drill and install a grommet for the IAC)
- 1″ air filter spacer (makes the install easier with more room over the fuel rails)
- MAP sensor and fuel pressure regulator vacuum tubing
- 3/8″ NPT plug for the intake runner #5 (when needed)
- ** Purchase a washable complete air Filter kit separately **
Smog & Emissions Compliant Low Profile Throttle Body – 7.5 Liter 460
** DOES NOT WORK WITH MAF (Mass Air Flow trucks) **
SPEED DENSITY HAVE 2 INTAKE TUBES CONNECTED TO THE AIR FILTER BOX
Included with this kit:
- This is our newest addition that includes extra components to retain the egr components
- Holley low profile throttle body, throttle cable and all needed sensors
- Throttle cable housing, inner-cable, and needed fittings for throttle and cruise control
- Idle air bypass, pigtail and tube
- Throttle position sensor and pigtail
- 5/8″ tubing and elbow for driver side breather port
- 14″ Air Filter Base (we drill and install a grommet for the IAC)
- 1″ air filter spacer (makes the install easier with more room over the fuel rails)
- MAP sensor and fuel pressure regulator vacuum tubing
- 3/8″ NPT plug for the intake runner #5 (when needed)
- ** Purchase a washable complete air Filter kit separately **
Stand-Alone Conversion Service
You can swap in a complete factory EFI 460 engine from a 1988-1997. If you already have a 460 that is still good you can take the heads and intake from the 88-97 and put them on any 460 engine. A 460 will even bolt up to the same bellhousing that a 351M or 400 will. Is it time to rebuild your 460 or Modified engine, or are you simply ready to ditch your carburetor and ignition system? Even if you’re just looking to add better fuel economy and power to your vehicle, an engine swap can be done in a day or two.